Need new dust collector filter bags?
You should know how to measure them and which dimensions are most crucial.
If you’re looking to exchange your filter bags, your initiative is to form sure you get the proper measurements. If you have a double beaded snap band dust collector filter bags, there are three crucial dimensions you should know in order for your supplier to get you the right replacements. We’re addressing those critical dimensions with this short instructional article below. We’re also sharing some recommendations on the way to get them measured right the primary time around. By spending a few of minutes on this article, you’ll avoid the foremost common problems people run into once they order the wrong dust collector filter bags.
Common Problems To Avoid:
- Unscheduled shut-down leading to production loss
- Clogged filters, causing a production delay
- Spending longer and money to urge the right set of filter bags
To measure a dust filter bag, you would like to urge three critical dimensions.
The first dimensions that we have to measure is that of the snap band size. This is often actually the opening size in your baghouse that the bag snaps into.
We also got to know the bag body diameter. Which is that the diameter of the bag, at the midsection of the bag. And we got to know the general length.
Let’s start by measuring the cell plate of the bag.
The best way to do this is to actually measure the hole in your baghouse, if you’re able to.
You should have here a sample of a hole; a cell plate hole in your baghouse. And to measure this, you want to take the tape and measure across the hole.
Don’t take and stick it like this, otherwise you won’t get a really accurate reading. Lay the tape across.
Start on variety that you simply can remember. Like I’m measuring on six. And measure to the widest a part of the opening.
And you would like to the closest sixteenth of an in. During this case, this bag has an exactly six inch cell plate hole.
If you’re unable to measure the cell plate hole in your baghouse, then the subsequent neatest thing is to be ready to snap your bag into cell plate templates of varied sizes to work out the dimensions of your cell plate.
This is a template I even have here, which happens to be a six and 1 / 4-inch hole. And I’m getting to take this bag and snap it in.
You hear it snap. It’s nice and tight. Then this bag fits a six and 1 / 4 cell plate holes.
The next measurement we need is the dust collector filter bags body.
And the way we measure this is often by laying the bag flat, smoothing it out, and easily measuring across the bag.
So, during this case, this bag measures about nine and three eighths across.
Once we all know the bag body, we will do some math to work out what the particular diameter is.
Lastly, we have to know the length.
When we have the length of the bag, we would like to live from the very end of the bag on the snap band side to the highest seam, or top stitch, on the rock bottom end of the bag.
This is where the particular disc bottom is, and where the within dimension of the bag would stop.
Imagine reaching your hand inside the bag and where your fingers would hit rock bottom of the disc, that’s where we’re trying to live to.
When we measure these bags, we would like to live along the seam. And that we want to tug it nice and comfortable, so there’s no sag. And measure thereto, top stitch. Again, to the closest sixteenth of an in.
In this case, this measures thirty-nine and five eighths of an in.
If you’e measuring a felt bag like this one, you’ll want to carry it up in the air once you stretch it tight to form sure you’re getting it tight.
If this bag was a woven material, the woven material tends to be more stretchy.
And so I like to recommend putting it on the table or the ground. You continue to want to tug it tight to require your measurement. That way you’ll get a more accurate reading.
With those three measurements; the length, the flat width of the bag, and your cell plate hole we will make the bag to suit your baghouse.